Determination of total carbon and total organic carbon from volatile air pollutants. Part I

Summary A new method of collection of representative air samples for the determination of TC and TOC from volatile air pollutants has been developed. The organic substances undergo combustion and only the carbon dioxide produced is concentrated on molecular sieve 5 A at ambient temperature. The CO₂ is subsequently liberated by thermal desorption at ca. 380°C in a stream of purified gas. Atmospheric CO₂ must be removed first and this can be done (at the sample flow rate of 700 ml/min) by a layer of Ascarite heated at 90° C. Organic compounds passing through the layer are then combusted by a dynamic method utilizing Körbl catalyst and the CO₂ formed is concentrated on a molecular sieve 5 A, followed by thermal desorption and final determination. Organic acids are also retained by the first CO₂ absorber. A diffusion cell for preparation of the mixtures of purified air with vapours of organic compounds is described.

---

Zusammenfassung Eine neue Anreicherungsmethode zur Gewinnung representativer Luftproben zur Bestimmung des Gesamtkohlenstoffgehaltes und des Gehaltes an organischem Kohlenstoff (TOC) aus flüchtigen Luftverunreinigungen wurde entwickelt. Während der Probenahme werden die flüchtigen Verunreinigungen verbrannt und nur das entstandene Kohlendioxid bei Zimmertemperatur am Molekularsieb 5A angereichert. Anschließend wird CO₂ bei ca. 380° C im gereinigten Gasstrom thermisch desorbiert. Bei der TOC-Bestimmung muß atmosphärisches CO₂ vorangehend aus dem Luftstrom entfernt werden und wird an einer auf 90° C erwärmten Ascariteschicht gebunden. Die durchfließenden organischen Verbindungen werden dann im dynamischen System am Körblkatalysator oxydiert, das entstandene CO₂ am Molekularsieb 5A angereichert, thermisch desorbiert und einer Endbestimmung zugeführt. Organische Säuren werden gleichfalls durch den ersten CO₂-Absorber gebunden. Eine Diffusionszelle zur Herstellung von Gemischen gereinigter Luft mit Dämpfen organischer Verbindungen wurde beschrieben.

     

ICP—AES法测定玩具材料中痕量砷,硒,锑

用电感耦合等离子体原子发射光谱法（ＩＣＰ－ＡＥＳ０测定了玩具材料中的痕量砷，硒和锑。方法简便快速，回收率为９７．５％－１０２．７％，相对标准偏差小于３％。     

Superabsorbent hydrogel composites

A new cost‐effective approach to enhance gel strength of superabsorbent hydrogels was invented. Superabsorbent hydrogel composites (SHCs) were prepared through an optimized rapid solution polymerization of concentrated partially neutralized acrylic acid in the presence of a crosslinking agent under normal atmospheric conditions. Kaolin was used as an inorganic component in the polymerization process to strengthen the hydrogel products. FT‐IR spectroscopy was used to confirm grafting of acrylic chains on to the surface of kaolin particles. Morphology of the products was studied by scanning electron microscopy (SEM). Compared with the kaolin‐free hydrogel (control), kaolin caused a reduced equilibrium swelling and swelling rate as low as 17–31% and 19–29%, respectively. Kaolin, however, resulted in enhanced gel strength as high as 21–35% compared to the control. Differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA) were used to study thermal properties of the composites. The SHCs exhibited higher thermal stability than the control. Meanwhile, changes in certain thermal transitions reconfirmed the chemical interaction of the acrylic chain with kaolin. These thermostabilized strengthened superabsorbent hydrogels may be considered as good candidates for agricultural application to retain more water under soil pressure. Copyright © 2003 John Wiley & Sons, Ltd.     

Carbon‐based Nanosensors for Salicylate Determination in Pharmaceutical Preparations

Thiourea derivative‐based carbon paste electrode (TUD1‐CPE) was constructed as a potentiometric sensor for the determination of salicylate anion in pharmaceutical formulations, Aspocid® and Aspirin®. The optimized CPE contained 45.5 % graphite, 0.5 % reduced graphene oxide (rGO), 46.0 % nitrophenyl octyl ether (NPOE) plasticizer, 5.0 % TUD1 ionophore, and 3.0 % tridodecylmethyl ammonium chloride as additive. The incorporation of NPOE of high dielectric constant, and rGO in electrode caused better performance of the sensor; Nernstian response of 59.0 mV decade^?1 in the concentration range of 10^?1–10^?5 mole L^?1, a detection limit of 1×10^?5 mole L^?1 in a very short response time of 6 seconds. The prepared sensor showed high selectivity against similar anions (i. e. , benzoate, I^?, SCN^?). Selectivity was confirmed by calculating the formation constant (K_β) using sandwich membrane method, where K_β for TUD1‐salicylate is 10^0.43. Theoretical calculations at DFT‐B3LY/6‐31G** level of theory were performed to find interaction mechanism, Energies of HOMO and LUMO orbitals, non‐linear optical (NLO) properties (the electronic dipole moment (μ), first‐order hyperpolarizability (β), the hyper‐Rayleigh scattering (β_HRS) and the depolarization ratio (DR)), and other global properties; these calculations showed lower values of β and DR, higher value of β_HRS, and the shortest lengths of the four N?H bonds between TUD1 and salicylate which confirm their strong complexation and salicylate‐selectivity. Also, all the studied anion‐TUD1 exhibited relatively high NLO properties, and these results were considered as a preliminary study for investigating new types of NLO bearing materials. The sensors were applied successfully for the determination of salicylate anion in Aspocid® and Aspirin®.     

Cycloarsanes (AsCF3)n (n = 4, 5) – Precursors for the Highly Reactive Diarsene F3CAs=AsCF3

Tetrakis(trifluoromethyl) cyclotetraarsane (F₃CAs)₄ ( 2 ) was used to repeat the UV initiated [4+2]‐cycloaddition reaction of the diarsene F₃CAs=AsCF₃ ( 1 ) with cyclohexa‐1,3‐diene (CHD) and to isolate single crystals of the cycloadduct 4 for a X‐ray diffraction analysis. 4 crystallizes in the space group and contains the diarsene group in its E‐configuration. 2 was also applied for [2+2]‐cycloaddition reactions of 1 with tBuC≡P and MeC≡CNⁱPr₂, but in contrast to positive results with (F₃CP)₄ the products were too labile for isolation. However, 2 was successfully used at room temperature as precursor for coordinating 1 as π‐donor ligand to the Pd(PPh₃)₂ complex fragment yielding η²‐bis(trifluoromethyl)diarsene‐bis(triphenylphosphane)‐palladium(0) 5 , which was characterized by X‐ray diffraction of single crystals and by spectroscopic investigations (NMR, IR, MS). Attempts to prove the existence of the diarsene 1 , generated by different methods, by spectroscopic studies very probably failed due to its extreme reactivity, not allowing the necessary concentrations for detection. Quantum chemical calculations of the stability of 1 with respect to dimerization, the stability of the [2+2]‐cycloadduct with 1‐di(isopropyl)aminopropyne and the energy difference between 4 and the 2,3‐dimethyl‐1,3‐butadiene cycloadduct of 1 were performed to understand the considerable differences between 1 and the related diphosphene F₃CP=PCF₃.     

热处理对Nylon—11结构的影响

对不同温度热处理过的Nylon－11样品，采用广角X射线衍射（WAXD），根据X射线衍射强度理论，用多重峰图解分峰方法研究了Nylon－11结构的变化，并导出了计算Nylon－11结晶度的公式．所得结果与密度法、DSC法进行了比较．同时也给出了Nylon－11的有关热力学参数，     

Thermal behavior of selected ferroelectric liquid crystals

Thermal properties of three ferroelectric liquid crystals, namely: 3-octyloxy-6-[2-fluor-4-(fluoroctyloxy)phenyl]-pyridine (FFP), 3-(3-fluor-nonyl)-6[4-heptyloxyphenyl]-pyridine (FNHPh-P), 4-[(S,S)-2,3-epoxyhexyloxy]phenyl 4-(decyloxy)benzoate (EHPhDB) were studied using heat flux differential scanning calorimetry method. All the transitions expected in this compounds, except the SmC^*-SmA^* and SmC^*-S₃ transitions, were detected in the DSC curves. The temperatures of the phase transitions and the enthalpy changes associated with them were determined. The transition from the liquid crystalline to the crystalline state showed significant hysteresis for all three compounds studied. The following transitions: SmA^*-Is, SmG^*-SmC^* for FNHPh-P, N^*-Is for EHPhDB, N^*-Is and SmC^*-N^* for FFP also showed a small hysteresis basing on which first-order character of all the above transitions was implied. All three substances studied in this work are characterized by a complex polymorphism in the solid state.The author is grateful to Dr. Stanislaw Wróbel for his stimulating interest, valuable discussions and supplying the samples. This work has been done in the framework of the KBN grant 2 P302 139 07.     

1,4-dioxane as a solvent in spectroscopy and photochemistry

Commercially available 1,4-dioxane, even of spectroscopic grade, contains various impurities that arise mostly from reaction of the solvent with oxygen. Aspects relevant to the spectroscopy and photochemistry of the dioxane/oxygen system are discussed. Methods of purification and storage of the solvent are presented.     

Hydrothermal Synthesis of Two New Transition Metal Coordination Polymers with Mixed Ligands

Hydrothermal reactions of 1, 2, 4‐benzenetricarboxylic acid, 1, 10‐phenanthroline and transition metal cations including Zn^II or Co^II, in basified aqueous solution gave rise to two complexes, [Zn₃(btrc)₂(1, 10‐phen)₂(H₂O)₂]_n ( 1 ), and [Co₃(btrc)₂(1, 10‐phen)₂(H₂O)₂]_n ( 2 ) (btrc = 1, 2, 4‐benzenetricarboxylate, and 1, 10‐phen = 1, 10‐phenanthroline). 1 2 crystalize isotypically in the triclinic space group P1¯. The btrc ligand acts as multi‐dentate bridging ligand in both compound 1 and 2 to link up transition metal atoms into lamella networks, which are further attached into three‐dimensional frameworks through complex hydrogen bonding and π‐π interactions. The photoluminescence spectrum for compound 1 has also been studied. The corresponding reaction with Cu²⁺ follows another pathway.     

Simultaneous determination of cocaine and its metabolites with caffeine in rat serum microsamples by high-performance liquid chromatography

A single, isocratic high-performance liquid chromatographic method is described for the determination of cocaine and three of its metabolites along with caffeine in serum microsamples (50 microliters). The small sample size permits the tracking of pharmacokinetic data over time in individual, small animals. The method also was used to demonstrate that cocaine, benzoylecgonine and norcocaine in rat serum samples were stable for at least a month without the presence of sodium fluoride.